Table of Contents
Advertisement
TRENDnet User's Guide
SNMP v2c Enable: Check to enable SNMP v2c.
•
ro community: Set a community string to authorize read-only access.
o
rw community: Set a community string to authorize read/write access.
o
•
SNMP v3 Enable: Check to enable SNMP v3.
SNMPv3 supports the highest level SNMP security.
SNMP ro user: Set a community string to authorize read-only access.
o
SNMP ro password: Set a password to authorize read-only access.
o
SNMP rw user: Set a community string to authorize read/write access.
o
SNMP rw password: Set a password to authorize read/write access.
o
SNMP Trap: Events such as cold start, interface up & down, and association &
•
disassociation will report to an assigned server.
© Copyright 2014TRENDnet. All Rights Reserved.
Community: Set a community string required by the remote host computer that
o
will receive trap messages or notices send by the system.
IP: Enter the IP addresses of the remote hosts to receive trap messages.
o
Click Save button to save changes and click Reboot button to activate.
Configure Time Policy
Configure time policy to apply on settings like access point Radio Schedule.
Policy: Select the policy to configure. Click Save Action to save settings.
•
•
Schedule Rule:
On Schedule: Select to have policy run on exact schedule
o
Out of Schedule: Select to have policy run outside of schedule.
o
Time Schedule:
•
Day of week: Select the days of the week to apply time policy
o
Start From: Enter time policy start time
o
TEW-738APBO
46
Advertisement
Table of Contents
