Hardware Setup And Configuration - TRENDnet TEW-740APBO Quick Installation Manual

2. Hardware Setup and Configuration

Note:
Ÿ The default IP address of the TEW-740APBO is 192.168.10.100. To configure the
TEW-740APBO, your network adapter must have an IP address within the 192.168.10.x
subnet (e.g. 192.168.10.10). Please refer to the Appendix in the User's Guide for more
information.
Ÿ The initial configuration should be completed in a testing environment with two
TEW-740APBO access points approximately 15 ft. (5 m) apart from one another with the
front of the access points directly facing each other.
Ÿ Configure and connect the access points before mounting.
Phase 1: Overview
In this installation guide, we will assume the following:
Router Settings:
Router/Default Gateway IP address: 192.168.10.1
Subnet Mask: 255.255.255.0
The TEW-740APBO access points will be configured with the following settings:
TEW-740APBO #1
IP Address: 192.168.10.50
Netmask (Subnet Mask): 255.255.255.0
IP Gateway (Default Gateway): 192.168.10.1
Primary DNS: 192.168.10.1
Wireless Channel (Default): 1
WDS AES Encryption
TEW-740APBO #2
IP Address: 192.168.10.51
Netmask (Subnet Mask): 255.255.255.0
IP Gateway (Default Gateway): 192.168.10.1
Primary DNS: 192.168.10.1
Wireless Channel (Default): 1
WDS AES Encryption
In this example, we will assume the device use the following MAC addresses:
TEW-740APBO #1 MAC Address: 00:11:22:33:44:00
TEW-740APBO #2 MAC Address: 00:11:22:33:44:11
2