Table of Contents
Advertisement
9.3
Adjustments
When the MaxiFeeder is used at an automatic
separation feeder, the separation is set
automatically.
Separation
When the MaxiFeeder is used at a manual
separation feeder it might be useful, before
adjusting the separation, to remove the
document hopper of the second feeder to obtain
easier access.
To adjust, proceed as follows (see figure below):
• squeeze the two blue handles A and B and
shift the feeding plate D as far as possible to
the front.
• push knob C forward until it clicks.
• place a document/BRE on the document feed
tray and slide it about 2.4 inch (60 mm) into
the machine. Turn knob C counter clockwise
if the separation is set to narrow.
• push the document/BRE between the rollers.
• turn knob C clockwise to get more resistance
or counter clockwise to lower the resistance.
A
The separation is adjusted correctly when a
slight resistance is felt on the document /BRE.
Pull knob C back again when ready.
Side guides
To adjust the side guides proceed as follows:
• take a stack of documents/BRE's and place
them in the feeder tray. BRE's with flap down
and leading.
40
B C
D
• adjust the side guides by turning the
thumbwheel A (see figure below) to provide
enough space to move freely. Too much play
causes skewing.
A
Filling the MaxiFeeder
To fill the MaxiFeeder proceed as follows (see
figure above):
• squeeze the two blue handles B and C.
• shift the feeding plate D to the rear position.
• fan the documents and place them in the
feeder tray. BRE's with flap down and leading.
The feeding plate assembly will be shifted up
automatically (when the system starts
processing) until documents/BRE's are
underneath the rubber paper pullers.
Note: when filling the MaxiFeeder be sure that
the document/BRE's are positioned parallel in
relation to the feed plate to ensure correct
feeding.
Note: when longer documents are used, plate D
can be extended by pulling out the adjustable
feed plate extension.
10. FAULT FINDING
10.1
General
In the system the following error types are
possible:
• paperflow errors.
• reading errors (when the system is equipped
with Optical Mark Reading).
• double document detection errors.
1-800-658-8788
www.abcoffice.com
B C
D
Advertisement
Table of Contents
