Table of Contents
Advertisement
Chapter 5 Trouble Guide
5
Close the top cover.
6
Insert the folding plate 1 and folding
plate 2.
0'"2-2. Folding plate" (p.89).
2-4.
Ejecting section
7
Press the 12'.f'-.J'e.. key on the control panel.
The paper is forcibly ejected.
Paper is ejected forcibly as long as the key is held down. Forcible ejection will stop by r eleasing the key.
3.
Troubleshooting
Do not use a flammable static electricity removal spray.
\Y
/::'\
Doing so could cause build-up of gas inside the machine,
which in turn could cause ignition, resulting in fire and explosion.
Condition
Power can not be turned
on.
The machine does not
start operation when the
¢
key is pressed.
The folding stopper of the
folding plates 1 or 2 does
not operate.
Paper is not folded at the
normal folding position.
94
&WARNING
Cause
The power cord is not connected.
Paper is not stacked.
The paper switch is not responding.
Paper has jammed.
The top cover is open.
Non-standard paper is used in standard
paper settings.
The paper feed guide is off the paper size
detection area.
Test folding is not performed even though
the setting is changed to on in [D-Feed
Detect).
Other non-standard paper is used.
The folding plates 1 and 2 are not set
properly.
The folding plates 1 and 2 are not set
properly.
Static electricity is built up on paper.
Solution
Connect the power cord.
Stack paper on the paper feed tray.
Stack paper in correct position so that the
paper switch responds.
Remove jammed paper.
(p.89)
Close the top cover.
Change the settings to match non-standard
paper.(p.51)
Secure the paper feed guide correctly.
Perform test folding.
(p.42)
Input the paper size.
(p.51)
Set the folding plates 1 and 2 properly.
Set the folding plates 1 and 2 properly.
.
Use a commercially available static
.
electricity removal spray.
.
Separate the paper well.
(p.31)
Humidify with a humidifier as required .
(p.34)
(p.89)
(p.89)
Advertisement
Table of Contents
