Table of Contents
Advertisement
• select if reverse reading is used (refer to
section "Reverse reading").
• select the required reading code.
• confirm settings by pressing "OK" which will
get you back to the "job settings" menu.
When OMR is switched on and the settings are
confirmed with OK, the DFC of the inserter is
automatically switched off. When required the
DFC can be set to on again in the "DFC
settings" menu. Also the daily mail of the upper
feeder is switched off and the amount of
documents is set to 1.
The highest output speed will be obtained when
feeder 1 has been selected as "reading feeder".
7.4
The OMR position
In the OMR position settings screen the position
of the first optical mark measured from the top of
sheet can be set. Select also the maximum
number of sheet.
When the OMR position is selected the following
choices are available (see figure below):
• go to the "Stop on misread" position settings
screen;
• select the position of the first optical mark,
measured from the top of the sheet;
• select the maximum amount of sheets in the
set of documents;
• confirm settings by pressing "OK" which will
get you back to the "job settings" menu.
The maximum amount of sheets in a set is 25.
When the documents have to be folded the
maximum amount of sheets in a set is 8; this is
related to the folding capacity.
When a set is exceeding the max. sheets
counter the system will divert this set or part of a
set immediately and error code 3:110 is
generated. Reset the error and press start key
to continue, the system will repeat the process
until an insert or divert mark is found.
The max. sheets value is including enclosures.
7.5
The stop on OMR Fault
When the "Stop on misread" settings is selected
the following choices are available (see figure
below):
• go to the "select OMR" settings screen.
• select "stop on misread" "YES" or "NO" after
an optical mark misread.
• confirm settings by pressing "OK" which will
get you back to the "job settings" menu.
When stop on OMR misread is set to "YES", the
machine stops after detecting an OMR
misreading. The incorrect set is diverted. After
resetting the machine, the next document set is
also diverted and the system starts processing
again. The diverted set(s) should be checked by
the operator.
When "stop on misread" is set to "NO" the
machine does not stop after detecting an OMR
misreading. The incorrect set is diverted. The
next set is also diverted and then the machine
starts processing again. After detecting 5 OMR
misreadings in a row, the system stops and an
error code is generated.
1-800-658-8788
www.abcoffice.com
29
Advertisement
Table of Contents
