Table of Contents
Advertisement
• grab the side guides in the middle and push
them towards the documents.
• the space between the side guides and the
documents should be such that the
documents have just enough play to move
freely.
• re-tighten knob B.
• remove the stack of documents.
Replace the document feed tray as follows (see
figure below):
• place the document feed tray under guide B.
• push the document feed tray up and then
lower it into position.
A
B
Filling the document feed tray
Open the left side guide A (see figure above) by
turning it downwards. The feed rollers will
automatically be lifted. Place a stack of
documents between the side guides. Turn the
left side guide upwards again.
Feed the documents (depending on the type of
documents and the type of fold) as shown in
"Feeding documents".
12
Adjustment of the document stoppers
Initially the document stoppers are adjusted for
position B (see figure below). In this position a
wide variety of documents can be handled (max.
297 mm; 11.7 inch) and adjustment is not
needed.
B
When a job is selected in which a different
stopper position has been programmed, the
operator has to put the document stoppers in
the correct position as indicated by the display.
For use of small documents of about 148 mm
(5.8 inch) or smaller, the document stoppers can
be set in the first position (position A).
For use of longer documents, maximal 356 mm
(14 inch), the document stoppers have to be set
in last position (position C).
To adjust the stopper position lift and hold the
collator arm D, squeeze the stopper and pull the
front side tab up. To replace the stopper, first
place the flat back tab into the slotted hole and
then push the stopper into position.
D
A
B C
1-800-658-8788
www.abcoffice.com
Advertisement
Table of Contents
