Extended Powerfold; General; Fold Settings Menu; Top Addressing - Formax 6600 Series Operator's Manual

Folder/inserters

Hide thumbs

Table Of Contents

Table of Contents

Reverse reading (optional)

Optional reverse reading is available. Reverse

reading means that the insert mark is on the first

page of the set. The system will detect the end

of a set by detecting the first page of the next

set. Because of the feeding and collating

principal reverse reading has the following

limitations:

• the last mark of the code should be printed

maximally 85 mm from the top.

• enclosures and selective enclosures cannot

be handled.

Examples of OMR code

The legend for the following example is shown.

In this example feeder station 1 is the reading

feeder. The feeder stations 2 and 3 are selected

for selective feeding.

mark printed

no mark printed

accumalate

insert

no selective feed

wanted, mark not

printed

selective feed

wanted, mark

printed

A set of 8 sheets with two selective feeds

(station 2 and 1) and three sequence check

marks is shown. The first position is used for the

start mark which must be printed on every

sheet. The second mark position is used for the

insert/ accumulate command. The mark is

printed on the last sheet of the set (inserting is

required). Position 3 and 4 are reserved for

selective feeding from station 2 and 1. Print a

mark on position 3 when a selective feed from

station 2 is required. Print a mark on position 4

when a selective feed from station 1 is required.

Position 5, 6 and 7 are used for the sequence

check marks.

Sheet 1 Sheet 2 Sheet 3 Sheet 4 Sheet 5 Sheet 6 Sheet 7 Sheet 8

8.1

When the system is equipped with the optional

"third fold table" and "turning unit", bottom

address applications and short folds are

possible.

When bottom address applications are used the

possible fold settings are "No fold", "Single fold"

and "Zig-zag fold". In case the "No fold" setting

inactive feeder 6

is used in the bottom address setting, the folding

inactive feeder 5

selective feeder 4

and inserting is performed the same as when

selective feeder 3

top address is selected.

selective feeder 2

reading feeder 1

8.2

After selecting the fold settings menu the

selection between "Top" or "Bottom" has to be

made (see figure below).

8.3

When "Top" address is selected shorter address

folds can be adjusted (except for the Zig-Zag

fold). The minimum address fold length is 25

mm. When the address fold is shorter than 75

mm the number of folded documents is limited

to 6 (in case of double parallel fold it is limited to

3).