Table of Contents
Advertisement
Only programmed jobs can be selected
(maximum of 20 jobs).
4.4
Main menu (2)
The "main menu (2)" shows the following
functions (see figure below):
• Job information (
).
• display contrast lighter.
• display contrast darker.
• Job menu (only for authorized personnel).
• go back to main menu (1).
4.5
Adjustments for document
feeding
Document separation
The document separation for the automatic
feeders is set automatically.
The document separation for special feeders
must be adjusted manually as follows (see
figure below):
• push the knob B forward until it clicks.
• open the left side guide A by turning it
downwards.
• place a document on the document feed tray
and slide it about 60 mm (2.4 inch) into the
machine (turn the knob B counter clockwise if
the separation is set to narrow).
• push the document between the separation
rollers, which are behind the rubber paper
pullers.
• turn the knob B clockwise to get more
resistance or counter clockwise to lower the
resistance.
A
The separation is adjusted correctly when a
slight resistance is felt on the document.
Pull the knob B back again when ready. Close
the left side guide A.
Side guides
To adjust the side guides it is best to remove the
document feed tray from the feeder as follows
(see figure below):
• push handle A downwards.
• lift the document feeding tray upwards to
unhook it and then pull it out from the feeder.
A
• loosen the knob B (see figure below) half a
turn.
• grab the side guides in the middle and move
them outwards.
• put a small stack of documents between the
side guides.
1-800-658-8788
www.abcoffice.com
B
11
Advertisement
Table of Contents
