Table of Contents
Advertisement
11. MAINTENANCE
11.1
Servicing
Disconnect the mains supply before
performing any maintenance.
The user must not attempt to service
the appliance beyond that described in
this operator manual. All other
servicing must be carried out by
qualified service personnel only.
Please contact your authorized
distributor.
11.2
General cleaning
The system must be kept in proper condition by
regularly removing dust, paper remains, etc.
Clean the sealing table and rubber rollers when
dirty. This can be done by using a slightly wetted
cloth soaked in warm water.
11.3
Cleaning the brushes
Clean the brushes when dirty or saturated with
glue. An extra set of brushes is provided. The
best procedure is to always soak one set of
brushes and use the other set. In that way there
is always a clean set of brushes ready for
usage.
To replace the brushes the upper unit must be
lifted (refer to "Operating controls). The brushes
can be removed one by one by pulling them
straight off the brush holder. When replacing the
brushes, align the studs on each brush with the
respective holes in the brush holder.
It is also possible to remove the brush holder
completely. Pull the tongue down and the brush
holder out of the upper unit. To replace the
brush holder, slide the tongue on the holder into
the upper unit and press downwards and
inwards to click in.
The brushes should be cleaned once a week.
11.4
Cleaning the moistening felt
Clean the moistening felt and water tray when
dirty or saturated with glue. To remove the water
tray the side cover must be opened (refer to
"Operating controls"). Then pull the locking
handle of the upper unit and lift the upper unit.
Pull out the water tray and clean it under running
water. Replace the water tray, lower the upper
unit until it clicks and close the side cover.
11.5
Cleaning the fold rollers
To clean the fold rollers in the PowerFold™
open the PowerFold™ cover (refer to
"Operating controls").
Clean the fold rollers in the PowerFold™
regularly with a dry duster or a cleaner (don't
use chemical products!).
12. OPTIONS
The following functions are optional and can be
set or fitted by the service organisation.
Optical Mark Reading (OMR)
The system can be equipped with optical mark
reading. With this reading the system reads
optical marks that have been specially printed
on the documents. This code contains
information about the processing of the
documents.
Extended PowerFold™
An extended PowerFold™ is available (factory
fitted) to extend the range of applications. With
this extended PowerFold™ bottom address and
short fold applications are possible.
MaxiFeeder MF-1
The system can be equipped with a MaxiFeeder
on feeding station 1. This MaxiFeeder is a high
capacity feeder and can contain up to 1200
sheets 20# 8 1/2 x 11".
Envelope support
Depending on the quality of the paper, the
conditions during storage, etc. envelopes can
be curved. This can cause smaller envelopes to
skew while being processed.
1-800-658-8788
www.abcoffice.com
49
Advertisement
Table of Contents
