Table of Contents
Advertisement
• select a lower feeder number.
• increase the number of documents of the
selected feeder.
• decrease the number of documents of the
selected feeder.
• confirm the settings by pressing "OK" which
will get you back to the "job settings" menu.
The number of sheet per feeder can be set
between 0 and 25. A feeder can be deselected
by setting the amount of documents to zero.
When a feeder is set to daily mail the amount of
documents is always 1. The maximum number
of sheets per feeder is 25. When folding is used
the maximum set thickness is 8 sheets (80 gr./
m2). When OMR is activated for a feeder the
amount of sheets per feeder can not be set.
Document size
When document size is selected, the following
choices are available (see figure below):
• go to the feeder swap screen.
• select a higher feeder number.
• select a lower feeder number.
• increase the document size of the documents
in the selected feeder.
• decrease the document size of the
documents in the selected feeder.
• confirm the settings by pressing "OK" which
will get you back to the "job settings" menu.
20
The document size can be set between 90 mm
(3.54 inch) and 356 mm (14 inch) in steps of 1
mm (0.04 inch).
The default document size setting of a new job
is 297 mm (11.7 inch). This is position B in the
collator area.
When the document size is decreased in such a
way that an earlier collator stop position can be
used, a screen will be shown when the OK key
or key 1 is pressed. When YES is selected,
each time the job is selected the paper stoppers
have to be set according to the job. When NO is
selected the original stop position will be used.
Feeder swap
When feeder swap is selected the following
choices are available (see figure below):
• go to the daily mail screen or when this is not
available to the "number of sheets" screen.
• select the pair of feeders which must be
linked.
• select link or unlink for a pair of feeders.
• confirm the settings by pressing "OK" which
will get you back to the "job settings" menu.
When a pair of feeders is linked, the settings of
the lower feeder will be used and shown in the
display.
When a feeder is selected for OMR the feeder
below can not be linked to this reading feeder.
1-800-658-8788
www.abcoffice.com
Advertisement
Table of Contents
