Table of Contents
Advertisement
• set the insert position to the left.
• save the insert position setting with "OK"
which will get you to the "main menu (1)".
First the insert position must be set. Then the
insert fingers must be adjusted. To check all
settings a test run can be made.
Envelope insert position
Press key 1 in the "Test run" menu to bring one
envelope onto the insert table. The flap folding
line must be positioned according to the line C
(see figure below) on the inserting table. If
necessary adjust the flap folding line position by
pressing key 4 or 5 in the "test run" menu.
Each key stroke stops the next envelope 0,5
mm (0.02 inch) to the right (earlier) or to the left
(later). Check the settings by pressing key 1
again.
A
B
Envelope insert fingers
To adjust the insert fingers A (see figure above)
loosen the knurled knob B on top of each finger.
Then adjust each finger so that the tip enters
about 5 mm (0.2 inch) into the envelope. Re-
tighten the knurled knob. The fingers can be
moved sideways to the desired position. Place
the outer fingers about 5 to 10 mm (0.2 to 0.4
inch) from the edges of the envelope.
Check the position of the insert fingers when
changing to a different type of envelope.
Counters menu
After pressing key 4 in the "main menu (1)", the
display shows the "counters" menu (see figure
below). The "counters" menu shows the
following functions:
• reset the daily job counter and stop counter to
zero.
• increase the preset counter.
• decrease the preset counter.
• save the counter settings with "OK" which will
get you back to the "main menu (1)". The
counter settings are job related.
The stop counter is switched off when it is set to
zero. The display will show "Stop at OFF".
The stop counter can be set between 0
(switched off) and 9999. The system will
continue until the job counter reaches the stop
counter value. The system stops and can be re-
started.
The stop counter value, the total counter value
and the done counter value are shown in the
"main menu (1)".
C
Inserting menu
When the start key is pressed the machine
starts inserting in automatic mode. The display
shows the "inserting" menu (see figure below).
1-800-658-8788
www.abcoffice.com
15
Advertisement
Table of Contents
