SATO HR2 Series Operator's Manual page 20

Section 2: Installation
2.3 LOADING MEDIA (cont'd)
3.
Release the lock levers of roll media guide and label
guide.
4.
Slide the roll media guide to the width of the roll media
and then load the media by latching the Roll media
assembly to the roll shaft bearing.
5.
Slide the label guide so that it fits the label width.
After alignment, lock the levers of roll media guide
and label guide.
Notes:
Make sure the media leader is pulled out from the top
and the printed side is facing upwards. Push the roll
firmly towards the end of the roll shaft bearing.
Page 2-4
Roll
media guide
lock lever
Roll
shaft
bearing
Roll
media
guide
HR2 Series Operator Manual
Roll
media
guide
Label
guide
lock lever
Label
guide
Label
guide