SATO HR2 Series Operator's Manual page 80

Section 3: Operation and Configuration
3.13 TEST PRINT MODE (Cont'd)
Item name (Print)
PCB Rev.
DSW
2)Second page --
Item name (Print)
Model Name
FROM1 CHECK SUM
LAN MAC Address
Pitch
Offset
Backfeed
Label Size
TearOff Offset
3)Third page --
Item name (Print)
Model Name
Life Counter
Page 3-40
Item name
CONT PCB's ver- x.x
sion
Dip switch setting ON/OFF
Item name
Model Name Printing the printer's model name.
Firmware's check-
Printing the checksum value in firmware area and
sum
CODE39 barcode.
(A) xxxx
(P) xxxx
(K) xxxx
Checksum value differs depending on firmware version.
LAN MAC Address xx:xx:xx:xx:xx:xx
Print start position Printing pitch position, offset position and backfeed value
Print stop position for each sensor type.
Backfeed amount +xx(dot)
+xx(dot)
+xx(dot)
Label Size Printing the label size set in the printer.
(P)xxxx x (W)xxxx(dot)
Tear Off Pitch Printing the offset for the first label in Tear off operation.
+x.xx(mm)
Item name
Model Name Printing the printer's model name.
Life Counter Printing the total usage.
xxxxx.x(km)
Description
Description
Head dot density
12 dot/mm
24 dot/mm
(B) xxxx
(E) xxxx
Description
Head dot density
12 dot/mm
24 dot/mm
Model
HR212
HR224
Model
HR212
HR224
HR2 Series Operator Manual