SATO HR2 Series Operator's Manual page 103

3.16 SERVICE MODE (Cont'd)
Menu
+
-
+
-
HR2 Series Operator Manual
BACKFEED OFFSET MODE
Adjusting the backfeed value for four GAP sensors. The number beside GAP
shows the position of the GAP sensor, ascending from the center to the right of
the printer.
Use + / - buttons to change the value.
"+": Increases backfeed value.
"-": Decreases backfeed value.
Setting range is ±0 - 72dot.
The default setting is "+00dot".
Press FEED to proceed to each GAP sensor to complete the settings.
Adjusting backfeed value for I-MARK sensor.
Use + / - buttons to change the value.
"+": Increases backfeed value.
"-": Decreases backfeed value.
Setting range is ±0 - 72dot.
The default setting is "+00dot".
Press FEED to save the setting and return to service mode menu.
Section 3: Operation and Configuration
Description
Page 3-63