SATO HR2 Series Operator's Manual page 27

2.4 LOADING THE CARBON RIBBON (cont'd)
7.
Load the carbon ribbon from the right side and make sure it latches into the ribbon supply shaft bearing
firmly.
Push in the ribbon shaft assembly to the right side of the ribbon supply shaft bearing. Then fix the other
side of the ribbon shaft assembly to the left of the ribbon supply shaft bearing. Turn the ribbon shaft until
the cross shape shaft snaps on the groove of the left ribbon supply shaft bearing.
Align to the cross-shape shaft bearing when
latching the ribbon.
Note:
Use only genuine SATO carbon ribbons for maximum print quality and printer durability.
HR2 Series Operator Manual
Ribbon supply
shaft bearing
Align to the round shape shaft bearing
when latching the ribbon.
Section 2: Installation
Page 2-11