Explanation Of The Contents Of Configuration Test Print - SATO HR2 Series Operator's Manual

Section 3: Operation and Configuration
3.13 TEST PRINT MODE (Cont'd)

3.13.4 Explanation of the contents of Configuration Test Print

1)First page --
Item name (Print)
Print Speed
Print Darkness
Print Offset
Zero Slash
Character Code
Character Pitch
Operation Mode
Backfeed Motion
Head Check
Auto Online
Initial Feed
Feed On Error
Command Error
LCD Power Saving
Protocol Code
Euro Code
Page 3-48
1.0 ~ 4.0 (inch/s)
Printing the print darkness and darkness range.
1A, 2A, 3A, 4A, 5A, 1B, 2B, 3B, 4B, 5B
Printing the offset position for printing.
For 12dot/mm: (H)±2400 (V)±672(dot)
For 24dot/mm: (H)±4800 (V)±1344(dot)
Zero with a slash through it: ON
Zero without a slash: Off
JIS code: JIS
SJIS code: SJIS
Unicode: Unicode
Proportional pitch: Proportional
Fixed pitch: Fixed
Printing the name of selected operation mode.
Continuous mode: Continuous
Dispense mode: Dispense
Tear-off mode: Tear Off
After printing (Motion 1): Action1
Before printing (Motion 2): Action2
No backfeed motion: None
When head check is disabled: None
When head check is enabled:
Checking actual print area: Normal
Checking barcode print area: Barcode
Yes/No
Enabled/Disabled
Enabled/Disabled
Printing the command error setting.
Prints Error: when enabled.
Prints Warning: when disabled.
Printing the transition time of LCD power save mode in minutes.
xx (min)
Standard code: Standard
Non-standard code: Non-Standard
Also, the protocol code set for the printer will be printed out.
STX:xxH, ETX:xxH, ESC:xxH, ENQ:xxH,
CAN:xxH, NULL:xxH, OFFLINE:xxH
xxH
Description
HR2 Series Operator Manual