SATO HR2 Series Operator's Manual page 32

Section 2: Installation
2.5 REMOVING THE CARBON RIBBON (cont'd)
4. Push the wound-up carbon ribbon to the right side
rewind shaft bearing
assembly.
Caution:
Be careful when removing the carbon ribbon, your hands
may get dirty while handling it.
5.
Remove the empty core from the ribbon supply shaft in
the same manner.
Note:
Don't dispose of the empty ribbon core after removing it from the ribbon supply shaft. Instead, transfer it to
the ribbon rewind shaft so that used ribbon can be wound around it after a new ribbon roll has been
loaded.
Page 2-16
to remove the ribbon rewind shaft
of the
HR2 Series Operator Manual