SATO HR2 Series Operator's Manual page 70

Section 3: Operation and Configuration
3.10 ADVANCED MODE (Cont'd)
1. During OFFLINE mode, press + and < buttons simultaneously to display the operational icon menu. Press
<, >, + or - buttons to select ADVANCE MODE.
2. When ADVANCE MODE is displayed, press the FEED button to enter to Advance mode for adjustment.
Note:
PASSWORD may prompt on the display if SET PASSWORD is set to ON in the Service mode. Please
refer to Section 3.16 Service Mode for details in password inputting.
3. DARKNESS RANGE is first displayed. Press the FEED button repeatedly will switch to the next setting
options as shown above. To return to the previous setting option, press LINE button. To return to
ADVANCED MODE screen, press and hold LINE button.
4. When the desired setting option is displayed, press <, >, + or - buttons to select the item or to set the value
and then press FEED button to save the setting.
Menu
Page 3-30
ADVANCED MODE
Setting print darkness range.
Available options are A and B, with B being the darker density.
C, D, E and F are reserved for future development.
The initial setting is at A.
Note: Adjustment of this setting is usually unnecessary.
Setting printing mode.
Allows the choices of dispenser, tear-off or continuous feed operation.
When DISPENSER is selected, the printer will proceed to BACKFEED
MOTION screen.
When TEAR OFF or CONTINOUS is selected, the printer will proceed directly
to SENSOR TYPE screen.
The initial setting is DISPENSER.
Allows the selection of the backfeed motion that will be applied before or after
the printing of each label.
AFTER: Backfeed motion after printing (Motion 1)
BEFORE: Backfeed motion before printing (Motion 2)
The initial setting is AFTER.
Set the pitch sensor to be selected relative to the media type to be used.
Either I-MARK sensor or GAP sensor can be selected.
The initial setting is GAP.
Setting gap sensors.
"GAP1": Set sensor on the far left to the printer.
"GAP2": Set sensor on the 2nd from the left to the printer.
"GAP3": Set sensor on the 3rd from the left to the printer.
"GAP4": Set sensor on the 4th from the left to the printer.
The default setting is "GAP2".
This screen is displayed only when "GAP" sensor is selected.
Description
HR2 Series Operator Manual