SATO HR2 Series Operator's Manual page 120

Section 5: Troubleshooting
5.1 ERROR SIGNAL TROUBLESHOOTING (Cont'd)
No. ERROR DISPLAY
16 ITEM NO ERROR
17
MEDIA ERROR
18
KANJI ROM ERROR
19
COMMAND ERROR
• Command
information of
detected error will
be shown at the
bottom of LCD.
20 SD CARD ACCESS
ERROR
21 SD CARD FULL
Page 5-4
LED BUZZER
STATUS: 3 short 1) Sequence number of print
Off Beeps
ERROR:
Blinks • Sequence number is not
To clear error: Press LINE
button or cancel job.
STATUS: 3 short 1) Rewinder is full.
Off Beeps
ERROR:
To clear error: Head open
Blinks
and then close or press
FEED button.
STATUS: 3 short 1) Reading improper Kanji
Off Beeps
ERROR: To clear error: Head open
Blinks and then close
STATUS: 3 short 1) Detecting improper
Off Beeps
ERROR:
Blinks • This screen appears only
To clear error: Press LINE
button.
STATUS: 1 long 1) SD card is not set in the
Off Beep printer
ERROR: 2) SD card is not set in the
Blinks printer correctly
3) SD card is removed from
the printer while accessing
to SD card
4) SD card read / write failure
5) Unformatted SD card is
used
6) Write protect SD card is
used
STATUS: 1 long 1) SD card is full.
Off Beep
ERROR:
To clear error: Power off
Blinks
ERROR CONDITION
data (for 1 item) is not
incrementing by one.
consecutive.
data through Kanji ROM.
command or parameter
while printing.
when command error
display is enabled in
Advanced Mode.
CORRECTIVE ACTION
1) Check host data and
communication settings.
1) Remove paper from rewinder.
1) Download Kanji data.
2) Board replacement.
1) Check print data.
1) Set SD card in the printer
2) Insert and remove SD card from
the printer
3) Insert SD card
4) Replace SD card
5) Format SD card via CARTRIDGE
mode
6) Remove write protect of SD card
1) Reserve free space in SD card.
HR2 Series Operator Manual