SATO HR2 Series Operator's Manual page 77

3.13 TEST PRINT MODE (Cont'd)
Menu
+
-
+
-
HR2 Series Operator Manual
TEST PRINT MODE
Choosing the Test Print Contents.
CONFIGURATION: The configuration settings of the printer will be printed.
BARCODE: The barcodes installed in this printer will be printed.
HEAD CHECK: The head check pattern of the selected media size area will be
printed.
HEAD SENSOR: The head check pattern and the sensor rating will be printed.
MEMORY: The contents of the memory in this printer will be printed.
FONT: The contents of the fonts installed in this printer will be printed.
SMALL PITCH: Test pattern for adjusting pitch for small pitch label will be
printed.
FACTORY1: The first half factory test print will be performed.
FACTORY2: The second half factory test print will be performed.
The initial value is CONFIGURATION.
If you chose test prints of Configuration, Barcode, Head Check or Head Sensor
in the previous menu, this screen lets you choose the width of the test print
from 03 to 06 cm (1.18" to 2.36"), in increments of 1 cm (0.39").
The initial size is 03cm (1.18").
For Factory test prints, this screen appears instead of the previous screen for
setting print size. In this screen, you can choose only to print the test results in
LARGE or SMALL print widths.
SMALL: Test print in 3cm (1.18") width
LARGE: Test print in 6cm (2.36") width
The initial value is LARGE.
Allows to select label size.
P: label length (mm)
W: label width (mm)
The initial value is 3 mm (0.12") long and 7 mm (0.27") wide.
Setting range is 03 to10 mm (0.12" to 0.39") for length and 7 to 56 mm (0.27" to
2.2") for width, both in increments of 1 mm (0.04").
Section 3: Operation and Configuration
Description
Page 3-37