SATO HR2 Series Operator's Manual page 130

Section 6: Basic Specifications
PRINT
Precision of print position
Precision of print expansion
Unprintable area
MEDIA
(Be sure to use media manufactured or certified by SATO)
Size
Type
Roll Diameter
Core Diameter
Thickness
Wind Direction
Page 6-2
Print start position:
Dispenser [GAP sensor] Within ±0.3 mm (0.012")
mode [I-Mark sensor] Within ±1.5 mm (0.059")
Width direction: Within ±0.3 mm (0.012")
Print start position:
Continuous [GAP sensor] Within ±0.3 mm (0.012")
mode [I-Mark sensor] Within ±1.0 mm (0.039")
Width direction: Within ±0.3 mm (0.012")
Print start position:
[GAP sensor] Within ±0.5 mm (0.019")
Tear-off mode
[I-Mark sensor] Within ±1.5 mm (0.059")
Width direction: Within ±0.3 mm (0.012")
Operating environment: Temperature 0 to 40°C (32 to 104 F)/Humidity 10 to 80%RH
(Non-condensing)
Using precise measurement labels with ±0.2 mm (0.008") tolerance is required.
Using the Gap sensor will provide better print start position accuracy as
*
compared to using the I-Mark sensor.
racy, label pitch and label detection motion may influence the accuracy of print start
position.
*The print accuracy above is tested based on specific conditions and is not guaran-
teed. Also, it does not include label assembly accuracy. Depending on label, ribbon
and label size conditions, it may not be possible to obtain the value above.
Within the range of ±1% toward paper feed direction
Top: 0.5 mm (0.019"), Bottom: 0.5 mm (0.019")
Pitch direction
(Not including liner)
Left: 0.5 mm (0.019"), Right: 0.5 mm (0.019")
Width direction
(Not including liner)
Label Continuous
Tear-off
Dispenser
** The above sizes are structurally possible; however, some restrictions may apply
depending on paper types, use environment and usage. Make sure to check the
paper size and corresponding print mode before operations.
Maximum outer diameter: 185 mm (7.3")
Label: 0.13 to 0.220 mm (0.005" to 0.008")
The difference in label processing accu-
Width: 7 to 58 mm (0.3" to 2.3")
Width including liner: 10 to 61 mm (0.4" to 2.4")
Pitch: 3 to 197 mm (0.1" to 7.7")
Pitch including liner: 6 to 200 mm (0.2" to 7.8")
Width: 7 to 58 mm (0.3" to 2.3")
Width including liner: 10 to 61 mm (0.4" to 2.4")
Pitch: 3 to 197 mm (0.1" to 7.7")
Pitch including liner: 6 to 200 mm (0.2" to 7.8")
Width: 7 to 58 mm (0.3" to 2.3")
Width including liner: 10 to 61 mm (0.4" to 2.4")
Pitch: 3 to 197 mm (0.1" to 7.7")
Pitch including liner: 6 to 200 mm (0.2" to 7.8")
Thermal Transfer
Use roll media specified by SATO.
Inner core diameter: 76.4 mm (3.0")
Face-Out
HR2 Series Operator Manual