SATO HR2 Series Operator's Manual page 89

3.13 TEST PRINT MODE (Cont'd)
2)Second page --
Item name (Print)
Reflective Sensor
Low [Lo<0.4] x.x(V)
High[0.9<Hi-Lo] x.x(V)
Slice Level Auto
Transmissive Sensor GAPx
Low [0.1<Lo<0.6] x.x(V)
High[0.9<Hi-Lo] x.x(V)
Slice Level Auto
Pitch(LCD)
Offset(LCD)
Darkness(LCD)
EXT Signal
EXT Dispenser
EXT Reprint
Label Size
DSW
3)Third page --
Item name (Print)
Keypad
DATA PORT
SUB PORT
Interface display
LAN
Protocol
RS-232C
Protocol
USB
Protocol
HR2 Series Operator Manual
Printing this information when reflective sensor (I-Mark) is selected.
If "Low" is not [Low < 0.4], "Low" will be indicated in reverse colors.
If "High" is not [0.9 < (High-Low)], "High" will be indicated in reverse colors.
Printing this information when transmissive sensor (GAP) is selected.
Indicates GAP sensor number in use by "x" in "GAP(x)".
If "Low" is not [0.6 < Low < 1.0], "Low" will be indicated in reverse color.
If "High" is [0.9 < (High-Low)], "High" will be indicated in reverse colors.
Printing the pitch position set through LCD screen.
±3.75(mm)
Printing the offset position set through LCD screen.
±3.75(mm)
Printing the print darkness set through LCD screen
00~99
TYPE1, TYPE2, TYPE3 or TYPE4
Enabled/Disabled
Enabled/Disabled
Printing the label size set in the printer.
(P)xxxx x (W)xxxx(dot)
ON/OFF
Enabled/Disabled
LAN / RS-232C / USB
None / RS-232C / USB / LAN
STATUS3
STATUS4 (ENQ)
STATUS4 (CYC)
STATUS5
READY/BUSY
XON/XOFF
STATUS2
STATUS3
STATUS4
STATUS5
STATUS4
STATUS5
Section 3: Operation and Configuration
Description
Description
Page 3-49