SATO HR2 Series Operator's Manual page 81

3.13 TEST PRINT MODE (Cont'd)
Item name (Print)
Head Counter1
Head Counter2/3
Dispenser Counter
Head-Check [All]
F-Pitch Offset(VR)
Reflective Sensor
Low [Lo<0.4] x.x(V)
High[0.9<Hi-Lo]
x.x(V)
Slice Level Auto
Transmissive Sensor
GAPx
Low [0.1<Lo<0.6]
x.x(V)
High[0.9<Hi-Lo]
x.x(V)
Slice Level Auto
Data/Sub Port
Pitch(LCD)
Offset(LCD)
Darkness(LCD)
Print Speed
Print Darkness
Print Offset
Operation Mode
HR2 Series Operator Manual
Item name
Head counter 1, 2, Printing the total usage of print head.
3 xxxxx.x(km)
Dispenser Counter Printing the dispenser usage.
xxxxx.x(km)
Head check result Performing head check and printing out its result.
Head check OK: OK
Head check NG: NG
(NG will be highlighted)
Factory Pitch Off- Printing the factory pitch offset.
set x.xx(mm)
Sensor type Printing this information when reflective sensor (I-Mark)
is selected.
If "Low" is not [Low < 0.4], "Low" will be indicated in
reverse colors.
If "High" is not [0.9 < (High-Low)], "High" will be indicated
in reverse colors.
Sensor type Printing this information when transmissive sensor
(GAP) is selected.
Indicates GAP sensor number in use by "x" in "GAP(x)".
If "Low" is not [0.6 < Low < 1.0], "Low" will be indicated in
reverse color.
If "High" is [0.9 < (High-Low)], "High" will be indicated in
reverse colors.
Data/Sub Port con- LAN ( / RS-232C / USB) / None ( / RS-232C / USB /
nection LAN)
Print position Printing the pitch position set through LCD screen.
adjustment value ±3.75(mm)
Stop position Printing the offset position set through LCD screen.
adjustment value ±3.75(mm)
Darkness adjust- Printing the print darkness set through LCD screen
ment value 00~99
Print Speed 1.0 ~ 4.0 (inch/s)
Print Darkness/ Printing the print darkness and darkness range.
Range 1A, 2A, 3A, 4A, 5A, 1B, 2B, 3B, 4B, 5B
Print Offset Printing the offset position for printing.
For 12dot/mm: (H)±2400 (V)±672(dot)
For 24dot/mm: (H)±4800 (V)±1344(dot)
Operation mode Printing the name of selected operation mode.
setting Continuous mode: Continuous
Dispense mode: Dispense
Tear-off mode: Tear Off
Section 3: Operation and Configuration
Description
Page 3-41