Joining Halves Of Crankcase - BMW C1 Repair Manual

•
Add the two measured values and the thickness
of the gasket (when compressed), 0.45 mm
(0.018 in).
•
Check installed length of crankshaft.
•
Allow for thickness of thrust washers.
Setting:
Crankshaft axial
play .........................0.2 - 0.4 mm (0.008 - 0.016 in)
•
Correct by changing thickness of washer in
drive-side half of crankcase.

Joining halves of crankcase

e
Caution:
Make sure that all bearings of crankshaft are ade-
quately lubricated.
C1111170
•
Working from the inside toward the outside,
tighten securing screws in diagonally opposite
sequence.
•
Fit new copper sealing ring (arrow).
•
Turn crankshaft through several complete revo-
lutions and check freedom of movement.
C1111180
11.67