BMW C1 Repair Manual page 379

72
Seat belts
Removing and installing
72 11 020
seat-belt central release unit
– Open the seat.
– Remove instrument panel.
– Remove top tunnel panel.
– Remove left and right service covers.
– Remove left and right rear side trim panels.
....................................................See Group 46
a
•
Loosen top, left and right tunnel panels.
•
Open cable ties (arrows).
•
Disconnect plug connection for seat-belt switch.
•
Remove fastener (arrow) of belt buckles on left
and right.
•
Mark Bowden cables (left and right/arrows) at the
holders.
•
Use a/f 11 open-ended wrench to release Bow-
den cables from holders.
•
Pull Bowden cables as far forward as possible.
C1720010
•
Press locking pin (arrow) of release unit and at
the same time pull the release unit to the rear hin-
to remove; pull out the Bowden cable at the
same time if necessary.
•
Disengage Bowden cables (2) on left and right.
•
Disengage Bowden cable core (1).
C1720020
C1720030
1
2
C1720040
72.3