When installing:
•
Spray shaft with lubricant
Materials:
Shaft ................................ Klüber paste 46 MR 401
Fastener, driving variator ...................... Loctite 243
e
Caution:
Make sure that belt is not trapped between the belt
plates
X
Tightening torque:
Fastener, driving variator
(+LOCTITE 243)........................................... 60 Nm
Cover, variator.............................................. 10 Nm
Ventilation cover............................................. 9 Nm
00.60
Checking wheel bearing play
(Inspections I, II and III)
L
Note:
Check bearing play only when cold.
•
Take the weight off the front/rear wheel
•
Tilt the front/rear wheel to and fro on the axle
•
No play should be detected
•
If play is detected in the wheel bearings, renew
them
................................................... See Group 36
a
Checking telescopic forks and all
spring struts for leaks
(Inspections II and III)
•
Visually inspect piston rods and fixed tubes
Checking locks
(Inspection IV)
•
Check function and freedom of movement