Replacing Grooved Ball Bearing For Engine Mount - BMW C1 Repair Manual

When installing:
1 Add coolant.
2 Slacken vent plug in cylinder head until liquid
emerges, then retighten vent plug.
3 Pour in remainder of coolant.
4 Briefly operate engine and correct coolant level
in expansion tank.
d
Caution:
Never re-use the original hexagon nut of the rear
wheel.
11.24
Replacing grooved ball bearing for
engine mount
– Housing halves separated
•
Using a pipe D=24.5 mm or a19 mm socket and
working from the inside, press out the bearing.
•
Using a mandrel D=34 mm or a 27 mm socket
and working from the outside, press in the bear-
ing.
C1110160
C1110170