System Alarm Setup - NEC Xen Topaz Programming Manual

Program 40 to 92
IN
SA
SB
Description
Use Program 90-10 : System Alarm Setup to assign a status to system alarms. You can designate an
alarm as Major or Minor. This program also assigns whether or not the alarm is displayed to a key tele-
phone and whether or not the alarm information is reported to the pre-defined destination.
Input Data
Alarm Number
Default
Alarm Type Report
1 2(MIN)
2 2(MIN)
3 2(MIN)
4 2(MIN)
5 0
6 0
7 1(MAJ)
8 1(MAJ)
9 0
Note
0 Board Initializa-
tion Error
0 Board Installation
Error
0 Communication
Error between
Board and EXIFU
0 PCB Program
Download Error
0 -Not Used-
0 Blocking (No de-
fault setting)
0 -Not Used-
0 RAM Backup
Battery Error
0 -Not Used-
P 90: M
ROGRAM
90-10: S
Is Used To Advise of...
Initialization Failure or the
PCB is defective
PCB was unplugged with-
out using the proper pro-
cedure.
PCB communication fail-
ure has occurred.
Download may have
failed because the PCB is
blocked (disabled) or the
sub -program does not
exist on the system flash
card.
-
Failure may have oc-
curred because:
• Terminal blocking
detected.
• Terminal is unplugged.
• Wire is disconnected.
• 308 card is defective.
-
RAM backup battery on
the 308M PCB is un-
plugged or defective.
-
Xen Topaz Programming Manual
P
AINTENANCE ROGRAM
A S
YSTEM LARM
001-100
Action
Remove and reinstall the
PCB.
Check the PCB installa-
tion.
Remove and reinstall the
PCB. If RECover mes-
sage is received in the
alarm report, the PCB is
good. If not, replace with
a new PCB.
After unblocking the PCB,
if RECover message is
received in the alarm re-
port, it is corrected. If not,
then replace the system
flash card.
-
Check the terminal wiring
and reconnect properly.
Then unplug and plug in
the PCB. If RECover
message is received in
the alarm report, it is cor-
rect. If not, replace the
PCB and/or terminal.
-
Check the battery con-
nector. If it is connected
correctly, then replace the
battery.
-
ETUP
317