NEC Xen Topaz Programming Manual page 30

Program 10 to 11
IN
SA
SB COPY
Description
Use Program 10-09 : DTMF and Dial Tone Circuit Setup to allocate the circuits on the 308M PCBs for
either DTMF receiving or dial tone detection. The 308M PCB has 16 circuits initially.
With additional DSPDBU is installed in 924M Main Cabinet, the system can provide a total of 32 (16+16)
circuits.
These are used as follows:
• Extension : DTMF receiver for SLT
• Trunk : DTMF receiver for analogue trunks, busy tone detection for analogue trunks
Input Data
Circuit/ Resource Number
01-32
Conditions
None
Feature Cross Reference
♦
Central Office Calls, Placing
♦
Direct Inward Dialling (DID)
♦
Direct Inward System Access (DISA)
Telephone Programming Instructions
To enter data for Program 10-09 (DTMF and Dial Tone Circuit Setup):
1. Enter the programming mode.
2. Enter 10 09
10-09-01 Res 1
DTMF DT Detect
3. Enter the number of the item you want to program.
10-09-xx Resxx
xxxxx
4. Select the Resource Number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you've exited that series' programming section.
P
ROGRAM
10-09: DTFM
Input Data
0 : Common Use
1 : Extension Only
2 : Trunk only
10: S C
YSTEM ONFIGURATION
D T
AND IAL ONE
Resource 01-32 = 0(Common)
*In case of 924M system:
01-32(Including DSPDBU:16+16)
Xen Topaz Programming Manual
S
ETUP
C S
IRCIUT ETUP
Default
23