IN
SA
SB
COPY
Description
Use Program 10-08 : Pre-Ringing Setup to enable or disable pre-ringing for trunk calls. This sets how a
trunk initially rings a telephone. With pre-ringing, a burst of ringing occurs as soon as the trunk's LED
flashes. The call then continues ringing with the normal ring cadence cycle. Without pre-ringing, the call
starts ringing only when the normal ring cadence cycle occurs. This may cause a ring delay, depending on
when call detection occurs in reference to the ring cycle.
Input Data
Conditions
None
Feature Cross Reference
♦
Central Office Calls, Answering
Telephone Programming Instructions
To enter data for Program 10-08 (Pre-Ringing Setup):
1. Enter the programming mode.
2. Enter 10 08
10-08-01
Pre-ringing
3. Enter the number of the item you want to program.
10-08-xx
xxxxx
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you've exited that series' programming section.
Xen Topaz Programming Manual
P
ROGRAM
Input Data
0 : disable
1 : enable
22
10: S
C
YSTEM
ONFIGURATION
10-08: P
Default
Program 10 to 11
S
ETUP
-
S
RE
RINGING
ETUP
0