Program 92: Copy Program; Irg Assignment For Normal Ring Trunk - NEC Xen Topaz Programming Manual

IN
SA
SB
Description
Use Program 92-01 : Copy Program to copy the data for one program to another keyset, port, group, etc.
Refer to the following charts to see which programs which can be copied.
Input Data
Program Number
Prog. No.
Source Number
92-01-01 Enter the extension, trunk, group, etc..
from which the data will be copied.
Destination Number (From)
Enter the first extension, trunk, group, etc.
92-01-02
number to which the information is to be
copied.
Destination Number (To)
Enter the last extension, trunk, group, etc.
number to which the information is to be
copied. If the information is only be cop-
92-01-03
ied to one extension, trunk, group, etc.,
enter the information entered in the Desti-
nation Number (From) entry.
Note) Copy Program is applicable only for the following programs.
1. Trunk Port Base
Prog. No.
Trunk Basic Data Setup
14-01
Analogue Trunk Data Setup
14-02
Behind PBX Setup
14-04
Music on Hold Source for Trunks
14-08
Conversation Recording Destination for
14-09
Trunk
Trunk Group Routing for Trunks
21-03
ISDN Calling Party Number Setup for
21-12
Trunk
Incoming Service Type Setup
22-02
Trunk Ring Tone Setup
22-03

IRG Assignment for Normal Ring Trunk

22-05
Second IRG Setup for unanswered DIL /
22-08
IRG
Incoming Ring Tone Audible on External
31-05
Speaker
Xen Topaz Programming Manual
Item
Program Name
332
P 92: C
ROGRAM
92-01: Copy Command
xx-xx
Input Data
• In case of Trunk Base ....
Trunk Port Number 1-51
• In case of Trunk Group Base....
Trunk Group Number 1-25
• In case of Extension Base....
Extension Number (Up to 4 digits)
• In case of Department Group Base....
Department Group Number 1-32
• In case of DSS....
DSS Console Number 1-9
Note
Copy all data except Trunk Name (14-01-01)
Program 40 to 92
P
OPY ROGRAM