Omron ZFV-C User Manual page 52

Section 2
Sensor Head
5.
Turn the focus adjustment control to the
left and right to adjust the focus.
For ZFV-SC10_/-SC50_
• Turn to right: Focuses to the far side.
• Turn to left: Focuses to the near side.
Default is focus set at furthest point.
For ZFV-SC90_/-SC150_
• Turn to right: Focuses to the near side.
• Turn to left: Focuses to the far side.
Default is focus set at nearest point.
If the workpiece is glossy, install the Sen-
sor Head at an angle to prevent mirror
reflection light from being picked up by the
sensor.
6.
Check the image.
ZFV-C
50
User's Manual
First turn the focus adjustment control slightly to the left and right, to make sure that the Focus
adjustment control is not at the upper or lower limit positions. The focus adjustment control is
a multi-turn potentiometer. However, the control stops turning at the upper or lower limit posi-
tions. Do not exert unnecessary force to turn the control at the upper or lower limit positions
as this might damage the control.
The focus adjustment control is a multi-turn potentiometer. However, the control stops turning
at the nearest position. Do not exert unnecessary force to turn the control as this might dam-
age the control. It turns free at the farthest position.
Mirror reflection light
TEACH/SEARCH TEACH/SEARCH
ABCDE
ITEM REG.
Focus
adjustment
control
ABCDE
ITEM REG.