Omron ZFV-C User Manual page 42

Section 2
Amplifier Unit
(6) TEACH (teaching input)
There are two teaching modes, workpiece stop teaching and workpiece move teach-
ing. These teaching modes can be selected in the menu.
(7) TRIG (measurement trigger input)
There are two measurement modes, synchronous measurement and continuous
measurement. Which mode of measurement is to be performed in is selected in the
menu.
Use a non-contact output (SSR, PLC transistor output) for the TRIG signal. If a con-
tact output (relay) is used, the trigger may be input a second time while measure-
ments are being taken due to the bounds of the contact.
(8) BANK1 (bank switching input 1)
(9) BANK2 (bank switching input 2)
(10) BANK3 (bank switching input 3)
The bank No. can be switched when BANK1 to BANK3 are connected as follows.
Bank No.
BANK1
BANK2
BANK3
BANK4
BANK5
BANK6
BANK7
BANK8
Timing Charts p.42
ZFV-C
40
User's Manual
Selecting the Teaching Mode from an External Device p.99
Selecting the Measurement Timing p.99
BANK1
OFF
ON
OFF
ON
OFF
ON
OFF
ON
BANK2 BANK3
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
ON ON
ON ON