Physis Piano K4 User Manual page 46

User Manual – General instrument settings (System Mode)
System Function: assign a system function to the wheel. A system function is a special function which is not saved
into Scenes, and therefore is always active and overrides Scene and Performance Settings.
Wheels can be assigned the same function of pedals (see the "Pedals" paragraph above n this chapter), except for
PERFORMANCE INCREMENT, PERFORMANCE DECREMENT, SCENE INCREMENT, SCENE DECREMENT,
SEQUENCER REMOTE REWIND, SEQUENCER REMOTE FORWARD, SEQUENCER REMOTE STOP, SEQUENCER
REMOTE PLAY, SEQUENCER REMOTE RECORD.
To select a function, use the encoder, the [DEC] and [INC] buttons or press [ENTER] to open a list of the available
functions.
Press [F2] to select the next wheel and visualize its information. Moving a wheel will select it and automatically open its
page.
Press the function buttons [F1], [F2], [F3] and [F4] to access the other video pages of the SETUP section.
To return to SYSTEM MODE, press [EXIT].
To return to PERFORMANCE MODE, press [SYSTEM] or [EXIT] two times.
Press a MODE button to access the corresponding operating mode.
NB
•
When a system function is selected, Scene functions are overridden. To underline this, the Type column of the
EDIT MODE \ PEDALS+WHEELS page (see chap. 5.7) says "SYSTEM".
•
An alternative way to access this page is pressing [F1] while on the WHEELS page in EDIT MODE.
AFTERTOUCH
Press [F3] to access the aftertouch calibration page:
Available parameters are:
Range Calibration: aftertouch range calibration (described below).
VALUE: read-only parameter, indicating the current aftertouch value; it is used for calibration. Minimum value (mildest
pressure) should always be 0%, while maximum value (strongest pressure on the key) should be 100%. If not so,
perform a calibration.
System Function: assign a system function to the aftertouch. A system function is a special function which is not
saved into Scenes, and therefore is always active and overrides Scene and Performance Settings.
Available system functions are: OFF, CHANNEL PRESSURE, MODULATION WHEEL, BREATH CONTROLLER.
To select a function, use the encoder, the [DEC] and [INC] buttons or press [ENTER] to open a list of the available
functions.
Press the function buttons [F1], [F2], [F3] and [F4] to access the other video pages of the SETUP section.
To return to SYSTEM MODE, press [EXIT].
To return to PERFORMANCE MODE, press [SYSTEM] or [EXIT] two times.
Press a MODE button to access the corresponding operating mode.
EN - 44