Physis Piano K4 User Manual page 45

-
LEGATO PEDAL (CC 68): Control Change message n.68 (Legato pedal)
-
REVEREB SEND (CC 91): Control Change message n.91 (reverb send effect)
-
CHORUS SEND (CC 93): Control Change message n.93 (chorus send effect)
-
CHANNEL PRESSURE: channel Aftertouch message
-
PITCH WHEEL: Pitch Bend message
-
MASTER VOLUME (GM): System Exclusive message Master Volume GM (general volume)
-
MASTER PAN (GM): System Exclusive message Master Pan GM (panning)
-
MASTER FINE TUNING (GM): System Exclusive message Master Fine Tunig GM (fine tuning)
-
MASTER COARSE TUNING (GM): System Exclusive message Master Coarse Tuning GM (tuning range)
-
PERFORMANCE INCREMENT: select next Performance
-
PERFORMANCE DECREMENT: select previous Performance
-
SCENE INCREMENT: select next Scene
-
SCENE DECREMENT: select previous Scene
-
SEQUENCER REMOTE REWIND: rewind message, as when pressing the [ ] button (for message type
selection, see ''SEQUENCER REMOTE'' in this paragraph)
-
SEQUENCER REMOTE FORWARD: fast forward message, as when pressing the [ ] button (for message type
selection, see ''SEQUENCER REMOTE'' in this paragraph)
-
SEQUENCER REMOTE STOP: stop message, as when pressing the [ ] button (for message type selection, see
''SEQUENCER REMOTE'' in this paragraph)
-
SEQUENCER REMOTE PLAY: play message, as when pressing the [ ] button (for message type selection, see
''SEQUENCER REMOTE'' in this paragraph)
-
SEQUENCER REMOTE RECORD: record message, as when pressing the [ ] button (for message type
selection, see ''SEQUENCER REMOTE'' in this paragraph)
To select functions, use the encoder, the [DEC] and [INC] buttons, or press [ENTER] to open the function list.
Press [F1] to select the next pedal and visualize its information. When a pedal is pressed, its configuration page appears
on the display, as if it were selected through the console.
Press the function buttons [F1], [F2], [F3] and [F4] to access the other video pages of the SETUP section.
To return to SYSTEM MODE, press [EXIT].
To return to PERFORMANCE MODE, press [SYSTEM] or [EXIT] two times.
Press a MODE button to access the corresponding operating mode.
NB
A system function overrides Scene functions. To remind you of this, in the EDIT MODE / PEDALS+WHEELS page
(see chapter 5.7) the Type column says "SYSTEM".
WHEELS
Press [F2] to access the programming and calibration functions for [WHEEL 1], [WHEEL 2] and [WHEEL 3] (in K4 models):
Available parameters are:
Pedal Type: this parameter indicates whether the wheel has is centred (that is, always returns to its central position)
like (la [WHEEL 1]), or is a free wheel, like [WHEEL 2] and [WHEEL 3].
Range Calibration: wheel calibration function (described below).
VALUE: read-only parameter, indicating the current position of the wheel; it is used for calibration. Minimum value
(downwards) should always be 0%, while maximum value (upwards) should be 100%. If not so, perform a calibration.
User Manual – General instrument settings (System Mode)
EN - 43