Configurating System Controls - Physis Piano K4 User Manual

User Manual – General instrument settings (System Mode)
3.
press the [ ] button to place the cursor on a parameter's name,
4.
press [ENTER]; to enter a new name, follow the procedure described at chapter 5.2.
Press the function buttons [F1], [F2], [F3] and [F4] to access the other video pages of the INSTRUMENTS section.
To return to SYSTEM MODE, press [EXIT].
To return to PERFORMANCE MODE, press [SYSTEM] or [EXIT] two times.
Press a MODE button to access the corresponding operating mode.

7.5 CONFIGURATING SYSTEM CONTROLS

Press the function button [F3] while in SYSTEM MODE to access calibration and programming options for pedals, wheels,
keyboard aftertouch and remote sequencer.
PEDALS
The first configuration page affects the pedals connected to the Jack PEDALS connectors on the rear panel:
Available parameters are:
Pedal Type: this parameter sets the type of pedal connected to the instrument. Select CONTINUOUS for continuous
control (expression) pedals; select SWITCH for foot-switch pedals.
Range Calibration (only for Pedal Type = CONTINUOUS): pedal range calibration, see description below.
Pedal Polarity (only for Pedal Type = SWITCH): pedal polarity, can be normal or inverted. For normal use, set the
polarity so that the VALUE polarity is set as 0% when the pedal is not pressed, and 100% when the pedal is pressed.
Select "AUTO" to have the system check automatically the polarity when switching on.
NB
•
If Pedal Polarity is set in AUTO mode, connect the pedals only while the instrument is switched off.
•
To access this page, you can also press [F1] from the PEDALS page in EDIT MODE.
VALUE: read-only parameter, indicating the pedal position, so as to allow calibration. Minimum position (or "off"
position, for foot-switch pedals) should always be 0%. Maximum position (or "on" position, for foot-switch pedals)
should always correspond to 100% value. If not so, calibrate the pedal or set the right polarity.
System Function: assign a system function to the pedal. System function are those functions that are not saved into
Scene, and therefore remain the same whatever Scene or Performance is currently selected.
Available system functions are:
-
OFF: no function assigned
-
MODULATION WHEEL (CC 1): Control Change message n.1 (modulation)
-
BREATH CONTROLLER (CC 2): Control Change message n.2 (breath controller)
-
FOOT CONTROLLER (CC 4): Control Change message n.4 (foot controller)
-
CHANNEL VOLUME (CC 7): Control Change message n.7 (channel volume)
-
BALANCE (CC 8): Control Change message n.8 (balance)
-
PAN (CC 10): Control Change message n.10 (stereophonic distribution, or panning)
-
EXPRESSION (CC 11): Control Change message n.11 (expression)
-
SUSTAIN PEDAL (CC 64): Control Change message n.64 (Sustain/Damper pedal)
-
SOSTENUTO (CC 66): Control Change message n.64 (Sostenuto)
-
SOFT (CC 67): Control Change message n.67 (Soft pedal)
EN - 42