Wheels And Pedals - Physis Piano K4 User Manual

User Manual – Checking and modifying a Performance (Info and Edit Mode)

5.7 WHEELS AND PEDALS

Press [F3] in INFO MODE and EDIT MODE to access the configuration pages about wheels and pedals (see also chap.
3.3 paragraphs "Pedals" and "Wheels"). These pages are almost identical and will be explained together.
The first page deals with the pedals connected to the [PEDAL 1] ... [PEDAL 8] connectors on the rear panel.
Press [F4] or move the cursor to the right to show the configuration page for wheels ([WHEEL 1], [WHEEL 2] and [WHEEL
3] for K4 models). Here, press [F3] or move the cursor to the left to return to the pedals page.
Press [F3] while on the PEDALS page to select the next pedal.
Press [F4] while on the WHEELS page to select the next wheel.
Pressing a pedal or moving a wheel will open immediately the configuration page for that control.
Available parameters are:
Type: The type of MIDI message sent or the function performed by the control,
-
OFF: no MIDI message assigned
-
CC: Control Change
-
NRPN: Non Registered Parameter Number
-
RPN: Registered Parameter Number
-
PITCH: Pitch Bend
-
PROG: Program Change
-
CH PRESS: Channel Pressure (channel aftertouch)
-
NOTE: note message (only for Switch pedals)
-
ZONE: activate / deactivate the Zone
If a system function has been assigned to a pedal or wheel (see chap. 7.5), this column will show the title ''SYSTEM''.
To disable system function for a Zone, just set the parameter as OFF.
NB
•
For the switch type pedals, the ZONE function is not performed if the operating mode is STEP (see parameter
Mode).
•
For the continuous pedals, functions NOTES and ZONE are not executed.
Message MSB-LSB: this parameter is Type dependent, can be:
-
CC: Control Change number;
-
NRPN e RPN: MSB and LSB numbers for Non Registered Parameter Number and Registered Parameter Number;
-
PG: MSB and LSB numbers of Bank Select messages.
PITCH and CH PRESS messages do not require this parameter.
Min: minimum value, transmitted when:
•
an expression pedal or wheel is at its lowest point
•
a switch pedal is not pressed (TOGGLE mode, see Mode parameter), is off (NORMAL mode), or at its first step
(STEP mode)
the message value can never go below its minimum.
Max: maximum value transmitted when,
•
an expression pedal or wheel is at its highest point;
•
a switch pedal is pressed (TOGGLE mode), is on (NORMAL mode), or at its last step (STEP mode);
PEDALS
EN - 30
WHEELS