Physis Piano K4 User Manual page 26

User Manual – Checking and modifying a Performance (Info and Edit Mode)
appear beside the Bank Select MSB and LSB numbers. If no names have been assigned, a line of dashes ("---") will
appear.
If, however, the send port is not a Virtual Instrument, pressing [ENTER] with the cursor on this parameter you can
assign a name to the Zone, usually that of the sound selected by the Program Change set. In this way, both in this box,
both in the PERFORMANCE MODE (see par. 4.3), you can be informed on the selected sound from a particular Zone.
The procedure of the composition of the name is the same as that described in par. 5.2.
To see the other pages of the ZONES section, press the function buttons: [F1], [F2], [F3] and [F4].
Press [EXIT] to go back to INFO MODE and EDIT MODE.
When in INFO mode, press [INFO] to go back to PERFORMANCE MODE. When in EDIT mode, press [EDIT] or [EXIT] two
times to return to PERFORMANCE MODE.
To access a different operating mode, press the related button, in the MODE section on the front panel.
NB
For further information on Virtual Instruments and Program Bank Tables, see chap. 3.3 and 7.4.
PARAMETERS
From the CONFIG page, pess [F2] or move the cursor to the left to see the second configuration page, the PARAMETERS
page. Here, the parameter transmitted when selecting a Scene can be configured, as well as the aftertouch (the pressure
on a key when it is completely lowered) responde curve and MIDI message:
VIEW=ALL
The following parameters are available:
Vol / Volume: the initial sound volume, set by Control Change 7. When OFF is selected, this Control Change is not
transmitted.
Pan (Pan-Pot): initial stereophonic distribution, set by Control Change 10. When OFF is selected, this Control Change
is not transmitted.
Rev / Reverb: initial reverb level, set by Control Change 91. When OFF is selected, this Control Change is not
transmitted.
Cho / Chorus: initial Chorus level, set by Control Change 91. When OFF is selected, this Control Change is not
transmitted
Note / Note Shift ±: Zone transposition (note shift) in semitones.
Tran / Transpose Enable: enable or disable transposition. Select YES to allow transposition, which can be controlled
by pressing the [TRANSPOSE] button. Select NO to disable.
Aftouch Message / Aftouch: this MIDI message is transmitted when using the aftertouch. It is possible to select:
-
OFF: none MIDI message transmitted
-
CH PRESS: Channel Pressure (aftertouch di canale)
-
CC: Control Change
-
NRPN: Non Registered Parameter Number
-
RPN: Registered Parameter Number
-
PITCH: Pitch Bend
AftCurve: aftertouch response curve. The following options are available:
-
NORM: linear curve, the transmitted MIDI value corresponds to the pressure value.
-
SOFT 1 e 2: soft curves; curve 1 is the softest.
-
HARD 1 e 2: hard curves, curve 1 is the hardest.
EN - 24
VIEW=SINGLE