Physis Piano K4 User Manual page 28

User Manual – Checking and modifying a Performance (Info and Edit Mode)
Lower: the minimum dynamic value accepted; keys pressed with a lower dynamic are not transmitted.
Upper: the maximum dynamic value. keys pressed with a stronger dynamic are not transmitted.
As the Polarity parameter, these two can be used to create dynamic layers. For example, set the same value for the
Lower parameter in a Zone and for the Upper parameter in another. When playing at a low dynamic, only the second
Zone will transmit notes and vice-versa.
The curves can be visualized thanks to the graphs of the Velocity Curve column (in view mode "ALL") or on the right side of
the page (in view mode "SINGLE"). The horizontal x-axis corresponds to key pressure, while the vertical y-axis corresponds
to the transmitted MIDI value.
To see other pages under the ZONES section, press the function buttons: [F1], [F2], [F3] or [F4].
Press [EXIT] to return to INFO MODE and EDIT MODE.
Press [INFO] to return to PERFORMANCE MODE if the system is currently in INFO mode. Otherwise, press [EDIT], or
press [EXIT] two times.
To access a different operating mode, press its corresponding button, in the MODE section of the front panel.
USER PROGRAMMED DYNAMIC CURVES
After selecting a USER dynamic curve, place the cursor on the Velocity Curve graphic and press [ENTER] (in VIEW mode
ALL). The following page will appear::
When VIEW mode is set as SINGLE, after selecting a USER dynamic curve
To access the Edit User Velocity Curve page, place the cursor on the EDIT field and press [ENTER]. To draw a curve,
add and place points as desired.
The Points parameter indicates the currently selected point, while X and Y are the point's coordinates. The slected point
appears as a red dot on the graph; red arrows around the dot show in which directions it can be moved. The first and last
points cannot be moved horizontally. Press [F3] to add a new point, after the selected one:
EN - 26