Physis Piano K4 User Manual page 36

User Manual – Checking and modifying a Performance (Info and Edit Mode)
Each row corresponds to an available map. The Input column indicates the MIDI input of the map, while the input channel
can be found in the first Ch column.
The Output column shows the Zone or the MIDI output port to which the ingoing data is transmitted, while the second Ch
column shows the output channel. To program a new map, select an empty row and press [F1]:
The following fields are available:
Input: the MIDI input port; data incoming from this port will be sent to an output.
In Channel: the MIDI input channel, related to the input port selected through the Input parameter. In ANY mode, all
channels are accepted: this mode is particularly useful when you want each received data to be redirected to a single
channel, set by the parameter Out Channel.
Output: the MIDI output port, to which the incoming data is transmitted. Set the input port and channel through the
Input and In Channel parameters. For Zones, the output is the same set by the Zone; otherwise, the name printed
beside the output port will be visualized, or the name of a Virtual Instrument. Virtual Instruments can be created
through the DEVICES function under the SYSTEM mode. Virtual Instruments can be disabled, but they are still
assigned to the Zone. When disabled, however, they will not send any MIDI message. Disabled Instruments appear in
grey.
NOTE
When the selected Output is a Zone, the data received from the MIDI port are always transmitted, regardless of the
Zone status (active, inactive, disabled).
Out Channel: MIDI output channel, related to the output port select through the Output parameter. Incoming data
from the Input port and In Channel is sent here. If you want the messages are not redirected to a MIDI channel other
than the one on which they are received, select the mode: ANY.
Filters: MIDI filters to prevent redirection of the following MIDI messages:
-
Note: note
-
Prog: Program Change
-
Ctrl: Control Change
-
SYSEX: System Exclusive
-
Sync: Start, Stop, Continue, MIDI Clock, MIDI Time Code, Song Position Pointer, Song Select
After the input map has been set, press [F3] or [EXIT] to cancel; press [F4] or [ENTER] to confirm the configuration. In any
case, the display shows the maps list.
From the same page, press [F2] to delete the selected map, or [F3] to modify it, following the procedure described above.
Press [EXIT] to return to INFO MODE and EDIT MODE.
Press [INFO] to return to PERFORMANCE MODE if the system is currently in INFO mode. Otherwise, press [EDIT], or
press [EXIT] two times.
To access a different operating mode, press its corresponding button, in the MODE section of the front panel.
EN - 34