Programming A Chain - Physis Piano K4 User Manual

User Manual – Sequence of Performances (Chain Mode)

6.3 PROGRAMMING A CHAIN

From any page, press the [CHAIN] button to access the following page:
Should the Chain be already programmed, the Chain Steps list shows the assigned steps. Empty steps appear as a string
of dashes ("----------------"). Place the cursor on the field by pressing the [ ] button. The page will appear as following:
Use the arrow buttons [ ] and [ ] to scroll the list. The same buttons used with the [SHIFT] button allow you to skip ten
steps.
To insert a new Performance, use the DATA ENTRY or KEY PAD controls.
To insert a new step, after the selected one, press [F3].
To remove the selected step, press [F4].
To skip to a different step without scrolling, press [F2]; the following page appears:
Now enter the number of the step using the KEYPAD buttons.
Press [F3] to delete data.
Press [F1] to select the first step, or [F2] to select the last available step.
Press [F4] or [ENTER] to confirm the selected step, or [EXIT] to abort.
While on CHAIN MODE, place the cursor on the Chain Name field and press [ENTER] to assign a name to the Chain. To
enter a new name, follow the procedure described at chap. 5.2.
Press [CHAIN] or [EXIT] to return to PERFORMANCE MODE.
To access a different operating mode, press its corresponding button, in the MODE section of the front panel.
NB
Changes to one or more Chains are automatically saved.
EN - 36