Control Banks - Physis Piano K4 User Manual

Use the arrow buttons [ ], [ ], [ ] and [ ] to move the point on the graph; alternatively, rotate the encoder to move the
point along the Y axis; rotate the encoder while pressing [SHIFT] to move the point along the X axis.
Press [F1] to select the previous point; press [F2] to select the next point.
Press [F4] to remove the selected point.
Press [EXIT] to save the curve and return to the previous page.
NB
•
The first and last points cannot be removed.
•
Points cannot be added before the first one or after the last one.
KEY RANGE
Press [F4] or move the cursor to the left to visualize the fourth Zone configuration page, KEY RANGE, where the portion of
keyboard assigned to each Zone can be modified:
VIEW=ALL
The value Lower or Lower Key is the lowest note of the portion of the keyboard assigned to the Zone, while Upper or
Upper Key is the highest note.
To select a key, use the normal procedure to enter data (described elsewhere) or press the key on your keyboard with the
[SHIFT] button pressed.
It also possible to set Lower values greater than Upper, and Upper values less than Lower: In this way the Zone continues
from the extreme top to the bottom, thus obtaining two distinct portions of the keyboard (see Zone4 in the screen with
VIEW=ALL depicted above).
To see other pages under the ZONES section, press the function buttons: [F1], [F2], [F3] or [F4]; alternatively, press the
arrow buttons [ ] and [ ].
Press [EXIT] to return to INFO MODE and EDIT MODE.
Press [INFO] to return to PERFORMANCE MODE if the system is currently in INFO mode. Otherwise, press [EDIT], or
press [EXIT] two times.
To access a different operating mode, press its corresponding button, in the MODE section of the front panel.

5.6 CONTROL BANKS

Press [F2] in either INFO MODE or EDIT MODE to program the CONTROLLERS section of the front panel (see also chap.
3.3, under the "Control Bank" pragraph).
BANKS
User Manual – Checking and modifying a Performance (Info and Edit Mode)
EN - 27
VIEW=SINGLE