Additional Messages - Physis Piano K4 User Manual

the message value can never be higher than its maximum.
Normally, the MIDI message assigned to a control is transmitted with its minimum value when the control is at its
lowest, as explained before. However, controls can be used in inverted mode, so that the maximum value is
transmitted when,
•
an expression pedal or wheel is at its lowest point
•
a switch pedal is not pressed (TOGGLE mode, see Mode parameter), is off (NORMAL mode), or at its first step
(STEP mode)
To do so, set the Max parameter to a lower value than the Min parameter.
Value: starting value, transmitted when a Scene is selected, calculated according to the range (set by Min and Max).
This field can be modified also by moving the control itself. The display will show the numerical value and a graphical
representation of that value.
Mode: (only for PEDALS), indicated the pedals function mode; can be
-
CONTINUOUS: continuous control. This mode is automatically selected by the instrument when the pedal is
configured as CONTINUOUS under the SETUP \ PEDALS page in SYSTEM mode.
-
NORMAL: maximum value is transmitted when the pedal is pressed; minimum value is transmitted when the pedal
is released. This mode can be selected when the pedal is configured as SWITCH under the SETUP \ PEDALS
page of the SYSTEM mode.
-
TOGGLE: pressing the pedal toggles between minimum and maximum value. This mode can be selected when a
pedal is configured as SWITCH under the SETUP \ PEDALS page of the SYSTEM mode.
-
STEP: the value increases by one unit each time the pedal is pressed. This mode can be selected when the pedal
is configured as SWITCH under the SETUP \ PEDALS page of the SYSTEM mode.
NB
The off - on range of pedals (in STEP mode) assigned to more than one Zone is the shortest of the set ranges. For
example, if the range is set as 0-127 for a Zone and 0 - 100 for another, the actual range of the MIDI messages will be
0-100.
Name: name associated to the panel control. To enter a name, follow the procedure described at chap. 5.2.
Press [F1] while on the PEDALS page to access the SETUP \ PEDALS page of the SYSTEM mode, to configure and
calibrate pedals. System function can be assigned from here.
Press [F1] while on the WHEEL page to access the SETUP \ WHEELS under the SYSTEM mode, to configure and
calibrate wheels. System functions can be assigned here.
These configuration pages for wheels and pedals are described at chap. 7.5.
To see the other pages of the PEDALS+WHEELS section, press the function buttons [F1], [F2], [F3] and [F4].
Press [EXIT] to return to INFO MODE and EDIT MODE.
Press [INFO] to return to PERFORMANCE MODE if the system is currently in INFO mode. Otherwise, press [EDIT], or
press [EXIT] two times.
To access a different operating mode, press its corresponding button, in the MODE section of the front panel.

5.8 ADDITIONAL MESSAGES

Press [F1] on the second page of the INFO MODE and EDIT MODE menus to access the programming pages. Here, the
messages sent when a Scene is recalled (see also chap 3.3, paragraph "Messagges") and input maps ("Input Map"
paragraph) can be programmed.
User Manual – Checking and modifying a Performance (Info and Edit Mode)
EN - 31