Physis Piano K4 User Manual page 34

User Manual – Checking and modifying a Performance (Info and Edit Mode)
Here a maximum of 8 MIDI messages can be programmed. These messages will be transmitted when the Scene is
selected, through the port and channel set by the Scene. The 8 messages appear in the 8 rows of the table.
The Output column shows the outputs through which the message is transmitted. The Message column corresponds to
the MIDI message and the Ch column indicates the MIDI channel.
NB
The REMOVE and EDIT functions can be recalled by pressing the function buttons [F2] and [F3]; they can be used
only if the cursor is placed on a row in which a message is currently present.
To insert a new message, place the cursor on an empty row, then press [F1]:
The available fields are:
Messagge Type: the transmitted message type,
-
CC: Control Change
-
NRPN: Non Registered Parameter Number
-
RPN: Registered Parameter Number
-
PROG: Program Change
-
SYSEX: System Exclusive
Send Mode: when to transmit the message, after a Scene has been recalled.
-
POST: after the Scene data package
-
PRE: before the Scene data package
This parameter is particularly useful to adapt to the type and function of a message. For a message that sets a global
function of the receiving device, such as single- or multi-sound mode, the message must be usually transmitted before
the sound configration data (set by the Scene). If the message is a sound control parameter, and the sound is
regulated by the Scene, the transmission must occur after the Scene data package, or the message will not work.
Output: the MIDI message transmission port. For Zones, the output is the same set by the Zone; otherwise, the name
printed beside the output port will be visualized, or the name of a Virtual Instrument. Virtual Instruments can be created
through the DEVICES function under the SYSTEM mode. Virtual Instruments can be disabled, but they are still
assigned to the Zone. When disabled, however, they will not send any MIDI message. Disabled Instruments appear in
grey.
NOTE
When the selected Output is a Zone, the message will always be transmitte, regardless of the Zone status (active,
inactive, disabled.
Channel: MIDI channel.
The next two fields are message dependent.
If the message is a Control Change, they are:
Control: Control Change number.
Value: Control Change value.
In the case of NRPN and RPN they are:
NRPN or RPN MSB: the message number of the NRPN or RPN MSB.
NRPN or RPN LSB: the message number of NRPN or RPN LSB.
EN - 32