Physis Piano K4 User Manual page 42

User Manual – General instrument settings (System Mode)
Channels: MIDI channels enabled to transmit data. To modify, place the cursor on a channel number and press [INC]
to enable or [DEC] to disable.
Press [F1] to select the next Virtual Instrument.
To see the other INSTRUMENTS pages, press the function buttons: [F1], [F2], [F3] or [F4].
To return to SYSTEM MODE press [EXIT].
To return to PERFORMANCE MODE press [SYSTEM] or [EXIT] two times.
Press a MODE button to access the corresponding operating mode.
PROGRAM BANKS
Once the Virtual Instrument has been selected and configured in the DEVICES page, a sound bank can be programmed.
Programming a sound bank allows to enter the sound list(s) into the receiving instrument. To do so, press [F2] or move the
cursor to the right:
In this page sound lists to a maximum of 8 can be programmed; these lists correspond to the sound banks of the external
device. Available parameters are:
Table Name: sound bank name; it will be shown when selecting Bank Select MSB and LSB messages (Bank MSB –
LSB column, ZONE \ CONFIG video page in EDIT MODE, see chap. 5.5). To enter a new name, place the cursor on
this field, then press [ENTER]; follow the procedure described at chap. 5.2.
Table Enable: enable (YES) or disable (NO) the sound bank; enabled banks appear in the Bank MSB – LSB and
Program Change columns on the ZONE \ CONFIG page, in EDIT and INFO MODE (see chap. 5.5).
Program Bank MSB and Program Bank LSB: MIDI MIDI Bank Select MSB and LSB number; when these messages
are received, the external device selects the sound bank.
Program Name: names of the Program Change, which will be displayed in the selection of Program Change
messages (Program Change column on the screen ZONE \ CONFIG in EDIT MODE, see par. 5.5), assigned on the
basis of sounds and/or programs in the external device. The numbers that appear in this field correspond to the
Program Change that in the receiving instrument are assigned to the sound/program. Read the user manual to see the
link between Program Change and name, then enter the same link here by following this procedure:
1.
press [ ] to place the cursor on the table,
2.
press the arrow buttons [ ] and [ ] to scroll through Program Changes and place the cursor on the desired one.
The same buttons used with the [SHIFT] button allow you to skip ten steps.
3.
press [ENTER] and follow the procedure described at chapter 5.2.
Press [F2] to select the next sound bank and visualize its information.
Press the function buttons [F1], [F2], [F3] and [F4] to access the other video pages of the INSTRUMENTS section.
To return to SYSTEM MODE press [EXIT].
To return to PERFORMANCE MODE press [SYSTEM] or [EXIT] two times.
Press a MODE button to access the corresponding operating mode.
EN - 40