Filling The Machine - Wexiodisk WD-7 DUPLUS Installation And User Manual

Instructions for use

4.1.3 Filling the machine

Switch on the power using the "0/1" button (9) on the panel. Close the hood. On
machines with automatic hood lift, the hood is closed with the button (5). The ma-
chine will start to fill.
The display (1) shows two dashes "--" until the machine is full. The other display
(4) shows "P0". P0 is a pause mode which indicates that no washing programme
has been selected. The symbol (2) is lit.
The final rinse symbol lights up when the heater is started
Once the dishwasher is full, the symbol (3) lights up and the display (1) shows the
temperature of the washing water. If the washing temperature falls below the set
value by more than 5° C, the temperature display flashes.
The symbol for the washing function lights up when when the machine is full and
the temperature display flashes when the washing temperature is too low
The water in the washing tank will continue to be heated until the correct washing
temperature has been reached. Heating time depends on the incoming water
temperature, the power of the booster heater and any options. The normal oper-
ating temperature for the washing phase is 60° C. The machine can be set up so
washing cannot start until the correct washing temperature hwas been reached.
Once the correct temperature has been reached, the washing pump will start and
run for a short period to mix the detergent.
WD-7 DUPLUS
C
6D_P0
C
6D_temp
31
Rev. (201403)