Operating Problems - Wexiodisk WD-7 DUPLUS Installation And User Manual

Instructions for use

4.3.8 Operating problems

CODE CAUSE
IF01/ The time needed to fill the tank has been exceed-
Er01 ed.
The level pipe is not in place.
The level pipe's rubber sleeve is not sealing
against the bottom plate.
The water stopcock is closed.
Er02 It has taken too long for the machine to heat up,
compared with the previous time.
Er04 Faulty temperature sensor.
Er05 Faulty temperature sensor.
IF06/ The booster heater is not cooled during the final
Er06 rinsing phase.
The water stopcock is closed.
IF09 Alarm for changing the water.
IF10 Alarm for weekly cleaning.
Er12 The break tank has not filled with water.
Er16 The temperature in the booster heater is too low.
Er23 The hood does not open when the automatic
hood opener is used.
Er27 The machine has lost all its set values.
IF29 Low water level in the tank for recirculating rinse.
IF30 Low water level in the washing tank.
The level pipe's rubber sleeve is leaking.
IF31 The tank for recirculating rinse water is not emp-
tied when rinsing finishes. The filter in the tank is
clogged.
Error messages
When the machine is operating, various alarms or information messages can ap-
pear on both the control panel displays. There is a distinction between IF and Er
alarms. IF alarms can normally be dealt with by the operator. If there is an Er
alarm, the service personnel must be called. Some IF alarms that have been dealt
with by the operator a few times will eventually change to Er alarms, meaning that
the service personnel must be contacted.
Each alarm has a number: 01, 02, 03 etc. The top display shows either IF or Er.
The bottom display shows the alarm number.
WD-7 DUPLUS
ACTION
The alarm can be reset by pressing 0/1 on the
panel.
Fit the level pipe.
Adjust the level pipe. Check that the rubber
sleeve has not been damaged. Replace the
sleeve, if it is damaged.
Open the stopcock.
The alarm can be reset by pressing 0/1 on the
panel. Contact service personnel if the alarm re-
curs.
Contact service personnel.
Contact service personnel.
The alarm can be reset by pressing 0/1 on the
panel.
Open the stopcock. Close the hood
Change the water. The alarm can be reset by
pressing 0/1 on the panel. If the alarm is not set
to stop the machine, the washing programme
can continue.
The machine must be cleaned more thoroughly
than during daily cleaning. The alarm can be re-
set by pressing 0/1 on the panel.
The alarm is reset automatically when the tank is
full.
The alarm can be reset by pressing 0/1 on the
panel. Contact service personnel.
The alarm can be reset by pressing 0/1 on the
panel. Contact service personnel if the alarm re-
curs.
Contact service personnel.
The alarm can be reset by pressing 0/1 on the
panel.
Check that the level pipe is closed. The alarm
can be reset by pressing 0/1 on the panel.
Check that the level pipe's rubber sleeve has not
been damaged.
Clean the filter. The alarm can be reset by press-
ing 0/1 on the panel. Contact service personnel if
the alarm recurs.
47
Rev. (201403)