Installation; General Information; Requirements For The Installation Site; Lighting - Wexiodisk WD-7 DUPLUS Installation And User Manual

Installation

3. Installation

3.1 General information

The machine must be installed by authorised personnel only.
Read these instructions carefully, as they contain important information regarding
the correct installation method.
Software version 2.3 or later should be used to connect a WD-PRM 7 to a WD-7
DUPLUS. If you are using an earlier software version this should be updated. The
level pipe in the dishwasher has been replaced with a bottom filter.
The instructions should be used together with the machine's wiring diagram and
flow diagram.
The machine is CE marked. The CE mark is only valid for machines that have not
been modified. If the machine is damaged as a result of the instructions not being
followed, this invalidates the supplier's guarantee and the product liability.

3.2 Requirements for the installation site

3.2.1 Lighting

In order to ensure the best possible working conditions during installation, opera-
tion, servicing and maintenance, make sure that the machine is installed in a well-
lit room.

3.2.2 Ventilation

The machine produces heat and steam when in operation. In order to ensure the
best possible working conditions, a certain air change rate is required in the dish-
washing room. The ventilation requirements for the room are dimensioned as per
applicable standards.

3.2.3 Drain

There must be a floor drain with an effective trap for the machine's waste water
and for water used for cleaning. The floor drain capacity can be found in the
TECHNICAL SPECIFICATIONS.
WD-7 DUPLUS
6
Rev. (201403)