Installation; Positioning The Machine - Wexiodisk WD-7 DUPLUS Installation And User Manual

Installation

3.4 Installation
Check that the overheating protection on the booster heater is set to zero.
If holes need to be made in the machine, each hole must be fitted with an edge
strip or similar protection.

3.4.1 Positioning the machine

Put the machine in position and check that it is horizontal using a spirit level. Place
the spirit level on the join between the machine tank and the hood. Once the ma-
chine has been filled with water, check that it is level.
If the machine is to be corner-loaded, it must be positioned with the control panel
furthest away from the wall.
Adjust the height using the machine's legs. The machine can also be fitted with
extension legs (35 mm).
Adjusting the folding basket path
Place the machine in level by adjusting the four feet so they have full contact with
the floor. Use spirit level.
Fill up your machine.
Lift basket guide (5) up and down and adjust foot 1 and 2 until the basket guide
is in the middle of the two supports 3 and 4.
If further adjustment of the machine's leveling is required, the legs are adjusted in
pairs (side, back or front).
WD-7 DUPLUS
47747
8
Rev. (201403)