Wexiodisk WD-7 DUPLUS Installation And User Manual page 30

Installation
1. Check:
•
•
•
•
•
2. Filling the machine:
•
•
•
•
3. Start the machine:
•
4. Check the setting of the reference values:
•
•
5. Run a number of washes complete with loads and check that:
•
•
•
•
•
•
•
6. Final check: Empty the machine and turn off the power using the mains
switch.
•
•
•
7. Train the dishwashing staff
WD-7 DUPLUS
Water and drain connections
That the machine is evenly balanced
Detergent and drying agent
Filters and level pipe are in place
The overheating protection on the booster heater is set to zero.
Turn on the mains switch and any circuit breakers
Close the hood
Fill the machine with water in accordance with the INSTRUCTIONS FOR
USE. (If the machine is not filled, check return valve that is located after the
booster heater.)
Bleed the hood lifting cylinder (option) in accordance with the manual
Check all pumps for direction of rotation
NOTE: If the direction of rotation is wrong, two phases should be switched
in the main contactor.
All the reference values have been set to the recommended values on de-
livery.
Check the temperatures.
There are no water leaks
The hood switch functions
The automatic hood lift functions (option)
The automatic hood closure functions (option)
The water temperatures are maintained
The washed items are clean
The washed items are dried
Note: The equipment for detergent and drying agent is roughly set at the
factory; contact your detergent supplier for a more precise setting.
Re-tighten all the connections on the relays and any circuit breakers
Set all the circuit breakers to the ON position
Display the maintenance instructions supplied with the machine.
26
Rev. (201403)